2pcs/Lot Standard Voltage Sensor Module Test Electronic Bricks For Arduino Robot Driver DIY Car RC Toy | Игрушки и хобби

Продавец: SR Robot Store
85 отзыв(ов) Написать отзыв

Цена:RUB

Стоимость в USD:Подробнее

Количество:

Где купить?

в избранное

Характеристики

2pcs/Lot Standard Voltage Sensor Module Test Electronic Bricks For Arduino Robot Driver DIY Car RC Toy | Игрушки и

Описание товара

Introduction This module is based on a resistive divider design principles, can reduce the voltage of the input terminal connection five times, analog input voltage up to 5V, then the input voltage of the voltage detection module can not be greater than 5V × 5 = 25V (3.3V if used system, the input voltage does not exceed 3.3Vx5 = 16.5V). Because AVR chips used in 10 AD, so the simulation resolution of this module is 0.00489V (5V / 1023), so the voltage detection module detects minimum input voltage is 0.00489V × 5 = 0.02445V. Parameters:

Input voltage range: DC0-25V
Voltage detection range: DC0.02445V-25V
Voltage analog resolutions: 0.00489V
DC Input: positive terminal connected to VCC, GND negative pole
Output interface: "+" then 5 / 3.3V, "-" then GND, "s" then the AD pin

Shipping List

Voltage Sensor Module: 1pcs

Reference Code: #include <Wire.h> int val11; int val2; void setup () { pinMode (LED1, OUTPUT); Serial.begin (9600); Serial.println ("Emartee.Com"); Serial.println ("Voltage:"); Serial.print ("V"); } void loop () { float temp; val11 = analogRead (1); temp = val11 / 4.092; val11 = (int) temp; // val2 = ((val11% 100) / 10); Serial.println (val2); delay (1000); }

Standard Voltage Sensor Module (2)

Написать отзыв